The use of new laptop batteries
When you buy a new battery or a new notebook computer, you will find that the battery is very little or no electricity, no computer has been launched. This is because the batteries after a long period of storage, and the laptop battery has a natural discharge process, the natural discharge has been completed, it will not affect the battery capacity. The first charge, you should continuously and to charge the battery to 12 hours, and cycle to fully charge, discharge three times (see maintenance of a battery) to fully awaken a new battery. If a battery by 12 hours after a row or three times after the charge and discharge cycle is still unable to charge, this battery can not use the need to be replaced.
Laptop battery maintenance
The rechargeable batteries are generally through chemical reaction to store the electronic energy, so its capacity is likely because of temperature, not the length of time, load the environment and affected by the frequency of use.
Following is on how to optimizing the maintenance batteries to extend battery life.
Began to charge the battery, the best, and so it is entirely necessary and sufficient, again after good use of it. If this is a new ibm battery, or you give it the first charge, it is possible because the batteries of the chemical properties but not sufficient to full capacity. To receive the maximum performance, battery of chemical materials must be fully activated. Specific:
Charge the battery completely discharge three times;
If this battery is stored for a few months does not use, I suggest you have it all three times the charge, discharge;
Only battery power to fully use it to end after the charge. Part of the charge, could lead to discharge the ThinkPad X60 battery inside the batteries of the chemical properties inconsistent and therefore battery performance will retreat down.
I suggest you batteries every few months to conduct a depth of discharge to optimize the performance of the battery. Specific approach is to use battery-powered, the battery capacity has been used to 0% (when the system will automatically enter sleep or standby status, according to different settings in the BIOS). Then connect the exchange has been full of chargers to 100 percent so far.
